About the Voltage Divider Calculator
What is the Voltage Divider Calculator?
A voltage divider uses two resistors in series to produce a fraction of the input voltage – a common way to scale signals for a microcontroller's ADC or to bias a transistor.
Enter a load resistance to see how a connected circuit pulls the output down.
How to use the Voltage Divider Calculator
- Input Voltage (V) (sample: 12)
- R1 – top resistor (Ω) (sample: 10,000)
- R2 – bottom resistor (Ω) (sample: 4,700)
- Load Resistance across R2 (Ω, 0 for none) (sample: 0)
- Press Calculate Output Voltage (results also refresh as you type). The result card shows the Output Voltage, along with Divider ratio, Current through R1, Power in R1 and Output without load.
Formula used
V_out = V_in × R2 ÷ (R1 + R2)
- With a load = replace R2 with R2 ∥ R_L = R2 × R_L ÷ (R2 + R_L)
Keep the load at least 10 times R2 to keep the output close to the unloaded value.
Worked example
These are the sample values already filled in the calculator above, and the result it returns for them:
| Input | Sample value |
|---|---|
| Input Voltage (V) | 12 |
| R1 – top resistor (Ω) | 10,000 |
| R2 – bottom resistor (Ω) | 4,700 |
| Load Resistance across R2 (Ω, 0 for none) | 0 |
| Result | Value |
|---|---|
| Output Voltage | 3.8367 V |
| Divider ratio | 0.3197 |
| Current through R1 | 0.8163 mA |
| Power in R1 | 6.664 mW |
| Output without load | 3.8367 V |
Tips for using the Voltage Divider Calculator
- Dividers are not voltage regulators – do not use them to power circuits that draw current.
- Lower resistor values reduce loading effects but waste more power.
